Dascom 7010 Programmers Manual DMX Manuel d'utilisateur télécharger pdf (Page 44)

Setting memory switch contents

Code

[02] V n

Setting

n is hex data expressing switch on and off with binary. Appropriate

ASCII codes are used for setting.

Bit

0 1 2 3 4 5 6 7

Auto-cutter 1 O O O O

Ribbon end sensor

Not care

Peeling sensor 3 O O O O

Function

With this command, memory switch contents can be changed

temporarily.

Example

When auto-cutter is turned to ON, n = 1 (binary 0001), i.e., 1 for hex,

so ASCII code 31hex is set. When peeling sensor is turned to ON, n =

4 (binary 0100), i.e., 4 for hex, so ASCII code 34hex is set.

Input data

When auto-cutter is turned to ON: [02] V 1

When peeling sensor is turned to ON: [02] V 4

Printer version number transmission request

Code

[02] v

Function

After receiving this command, printer transmits the control ROM

version number and date to the computer in ASCII code.

Caution

Printer sends data on printer status to the computer as soon as it

receives this command. Therefore, the computer must be ready to

receive data from the printer immediately after receiving this

command.

The [0D] hex code is added to the end of the transmission data.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 155 156

Pas de commentaire

Dascom 7010 Programmers Manual DMX Manuel d'utilisateur Page 44