Dascom TallyCom III Installation & Operators Guide Manuel d'utilisateur télécharger pdf (Page 48)

Appendix C. Error Messages

C.1 Recoverable errors

Recovery procedure from these errors is as follows:

Correct the error from the host system according to the error message.

The recoverable error messages consist of the following:

ESCAPE SEQUENCE ERROR XXXX

where XXXX indicates one of the following diagnostic messages:

2001 Escape sequence ERROR in call function # 001

2nnn Escape sequence ERROR in call function # nnn

2255 Escape sequence ERROR in call function # 255

2303 Function not supported

2309 Illegal separator

2311 Syntax ERROR

3002 No space left in dynamic area

C.2 Non-recoverable hardware errors

Recovery attempt can be made as follows:

Turn power off for 10 seconds and then on again.

If the problem persists, contact technical assistance.

The non-recoverable error messages consist of this message:

HARDWARE MALFUNCTION. Call for service. XXXX

where XXXX indicates one of the following diagnostic messages:

Non-Volatile Memory Error:

5002 Hardware ERROR in NVRAM

5003 Checksum in NVRAM is wrong

5004 Validation value in NVRAM is wrong

5005 NVRAM verification ERROR in cell

5006 Values are now overwritten by factory defaults

EPROM Error:

6001 EPROM checksum ERROR

RAM Error:

7001 Main processor RAM ERROR

Interface Error:

8002 Wrong data in selftest

8003 Wrong word in selftest

8004 Response missing from COAX IF.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

ok 11 Feb 2024 | 07:50:22

yes

Dascom TallyCom III Installation & Operators Guide Manuel d'utilisateur Page 48