– 1 –Installation Guide 7106 7206User Guide Peeler Unit
– 10 –3 How to operate3-1 Operation3 How to operate 3-1 Operation3-1-1 Peeler door opening/closing (1) Opening Shift the release knob of the peeler
– 11 –3 How to operate3-1 Operation3-1-4 Initial value of peeling position The paper position for peeling off the label can be adjusted in the printe
– 12 –3 How to operate3-1 Operation3-1-5 Peeler commands The following are the peeler commands. For details of each command, see the separate Command
– 13 –4 Peeler specifications 4 Peeler specifications Width of liner (a) : 1 − 4.65 in (25.4 − 118 mm) Length of label (b) : 1 − 4.72 in (25.4 − 1
DASCOM REPRESENTATIVESGERMANYDASCOM Europe GmbHHeuweg 3D-89079 UlmDeutschlandTel.: +49 (0) 731 2075 0Fax: +49 (0) 731 2075 100www.dascom.comSINGAPORED
– 2 –© August 2010 DASCOM Europe GmbH
– 3 –Installation Guide0 The following installation shows a 7106 printer. The peeler installation for 7206 printers follows the same steps.1 Before in
– 4 –1-3 Remove the screw (M3 X8, for plastic) and take the connector cover out as shown below.2 Installing the peeler2-1 While inserting the peeler c
– 5 –2-2 Connecting the peeler unit cableConnect the peeler unit cable connector to the receptacle of the printer after setting the peeler cable in th
– 6 –3 Reinstalling the coversReinstall the connector cover (M3 X 8, for Plastic) and the motor cover (M3 X 6).Note: Keep the front cover for future u
– 7 –User GuideContents Caution・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・81 Outline・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・92
– 8 –Caution Company names and product names in this manual are trademarks or registered trademarks of relevant companies. CAUTION Always use the p
– 9 –1 Outline/2 Exterior view and part names 1 Outline This peeler unit is designed to automatically remove the label from the liner. 2 Exterior vie
Commentaires sur ces manuels